Subversion Repositories FlightCtrl

Rev

Go to most recent revision | Show changed files | Directory listing | RSS feed

Filtering Options

Rev Age Author Path Log message Diff
1422 /  
1421 /  
1420 /  
1419 /  
1418 /  
1417 /  
1416 /  
1415 /  
1414 /  
1413 /  
1412 /  
1411 5330 d 15 h martinchzh /branches/V0.76g_VarMotorSmoothing/Hex-Files/ compiled HEX, Display: "SW:0.76g vMS"  
1410 5330 d 15 h martinchzh /branches/V0.76g_VarMotorSmoothing/ compiled HEX  
1409 5330 d 16 h martinchzh /branches/V0.76g_VarMotorSmoothing/ MotorSmoothing Option in Userparameters 1 and 2  
1408 5330 d 22 h martinchzh /branches/V0.76g_VarMotorSmoothing/ Motor Smoothing Option in Userparameters  
1407 /  
1406 /  
1405 /  
1404 /  
1403 /  
1402 5338 d 20 h acid /branches/V0.76g-acid/Hex-Files/  
1401 5340 d 14 h acid /branches/V0.76g-acid/  
1400 5341 d 21 h acid /branches/V0.76g-acid/  
1399 /  
1398 /  
1397 5345 d 15 h Arthur P /branches/V0.76g-Arthur P/  
1396 5345 d 15 h Arthur P /branches/V0.76g-Arthur P/  
1395 5345 d 15 h Arthur P /branches/V0.76g-Arthur P/Hex-files/  
1394 5345 d 15 h Arthur P /branches/V0.76g-Arthur P/Hex-files/  
1393 /  
1392 /  
1391 /  
1390 /  
1389 5346 d 12 h Arthur P /branches/V0.76g-Arthur P/Hex-files/  
1388 5346 d 12 h Arthur P /branches/V0.76g-Arthur P/ V0.76g-Arthur P implements the same changes I had in 0.74d-Arthur P;
* Motorsmoothing downwards over a user parameter
* Use of external HEF4017 on modified FC 1.x hardware
* Roll, tilt and shutter out over HEF4017 if active
It does NOT use the user parameter anymore for setting
direction and offset for the roll servo as this is now done over the MK Tool Camera screen.		  
1387 5346 d 12 h Arthur P /branches/V0.76e Code Redesign killagreg/  
1386 5346 d 12 h Arthur P /branches/V0.76e Code Redesign killagreg/V0.76g-Arthur P/ V0.76g-Arthur P contains the same mods I had introduced into V0.74d-Arthur P: use of an external HEF4017 on modified FC 1.x hardware for roll, tilt and shutter output over J7/J9, and motorsmoothing. Of note, the exact setting over the roll compensation now occurs through the MKTool, no longer over a user parameter. The user parameter is only needed to activate the routine for FC1.x hardware.  
1385 5346 d 12 h Arthur P /branches/  
1384 5346 d 12 h Arthur P /branches/  
1383 5346 d 12 h Arthur P /branches/