Rev 1479 |
Go to most recent revision |
Blame |
Last modification |
View Log
| RSS feed
/*#######################################################################################
Flight Control
#######################################################################################*/
#ifndef _FC_H
#define _FC_H
//#define GIER_GRAD_FAKTOR 1291L // Abhängigkeit zwischen GyroIntegral und Winkel
//#define GIER_GRAD_FAKTOR 1160L
extern long GIER_GRAD_FAKTOR; // Abhängigkeit zwischen GyroIntegral und Winkel
#define STICK_GAIN 4
#define FCFLAG_MOTOR_RUN 0x01
#define FCFLAG_FLY 0x02
#define FCFLAG_CALIBRATE 0x04
#define FCFLAG_START 0x08
#define FCFLAG_NOTLANDUNG 0x10
#define FCFLAG_LOWBAT 0x20
#define FCFLAG_SPI_RX_ERR 0x40
#define FCFLAG_I2CERR 0x80
#define Poti1 Poti[0]
#define Poti2 Poti[1]
#define Poti3 Poti[2]
#define Poti4 Poti[3]
#define Poti5 Poti[4]
#define Poti6 Poti[5]
#define Poti7 Poti[6]
#define Poti8 Poti[7]
#define CHECK_MIN_MAX(wert,min,max) {if(wert < min) wert = min; else if(wert > max) wert = max;}
extern volatile unsigned char FCFlags;
extern volatile unsigned int I2CTimeout;
extern unsigned char Sekunde,Minute;
extern unsigned int BaroExpandActive;
extern long IntegralNick,IntegralNick2;
extern long IntegralRoll,IntegralRoll2;
//extern int IntegralNick,IntegralNick2;
//extern int IntegralRoll,IntegralRoll2;
extern unsigned char Poti[9];
extern long Mess_IntegralNick,Mess_IntegralNick2;
extern long Mess_IntegralRoll,Mess_IntegralRoll2;
extern long IntegralAccNick,IntegralAccRoll;
extern volatile long Mess_Integral_Hoch;
extern long Integral_Gier,Mess_Integral_Gier,Mess_Integral_Gier2;
extern int KompassValue;
extern int KompassStartwert;
extern int KompassRichtung;
extern int TrimNick, TrimRoll;
extern long ErsatzKompass;
extern int ErsatzKompassInGrad; // Kompasswert in Grad
extern long HoehenWert;
extern long SollHoehe;
extern int MesswertNick,MesswertRoll,MesswertGier;
extern int AdNeutralNick,AdNeutralRoll,AdNeutralGier, Mittelwert_AccNick, Mittelwert_AccRoll;
extern int NeutralAccX, NeutralAccY,Mittelwert_AccHoch;
extern unsigned char HoehenReglerAktiv;
extern volatile float NeutralAccZ;
extern long Umschlag180Nick, Umschlag180Roll;
extern signed int ExternStickNick,ExternStickRoll,ExternStickGier;
extern unsigned char Parameter_UserParam1,Parameter_UserParam2,Parameter_UserParam3,Parameter_UserParam4,Parameter_UserParam5,Parameter_UserParam6,Parameter_UserParam7,Parameter_UserParam8;
extern int NaviAccNick,NaviAccRoll,NaviCntAcc;
extern unsigned int modell_fliegt;
void MotorRegler(void);
void SendMotorData(void);
void CalibrierMittelwert(void);
void Mittelwert(void);
void SetNeutral(void);
void Piep(unsigned char Anzahl, unsigned int dauer);
extern unsigned char h,m,s;
extern volatile unsigned char Timeout ;
extern unsigned char CosinusNickWinkel, CosinusRollWinkel;
extern int DiffNick,DiffRoll;
//extern int Poti1, Poti2, Poti3, Poti4;
extern volatile unsigned char SenderOkay;
extern volatile unsigned char SenderRSSI;
extern int StickNick,StickRoll,StickGier;
extern char MotorenEin;
extern void DefaultKonstanten1(void);
extern void DefaultKonstanten2(void);
extern void DefaultKonstanten3(void);
extern void DefaultStickMapping(void);
extern unsigned char Parameter_Servo3,Parameter_Servo4,Parameter_Servo5;
extern char VarioCharacter;
#define STRUCT_PARAM_LAENGE sizeof(EE_Parameter)
struct mk_param_struct
{
unsigned char Kanalbelegung[12]; // GAS[0], GIER[1],NICK[2], ROLL[3], POTI1, POTI2, POTI3
unsigned char GlobalConfig; // 0x01=Höhenregler aktiv,0x02=Kompass aktiv, 0x04=GPS aktiv, 0x08=Heading Hold aktiv
unsigned char Hoehe_MinGas; // Wert : 0-100
unsigned char Luftdruck_D; // Wert : 0-250
unsigned char MaxHoehe; // Wert : 0-32
unsigned char Hoehe_P; // Wert : 0-32
unsigned char Hoehe_Verstaerkung; // Wert : 0-50
unsigned char Hoehe_ACC_Wirkung; // Wert : 0-250
unsigned char Hoehe_HoverBand; // Wert : 0-250
unsigned char Hoehe_GPS_Z; // Wert : 0-250
unsigned char Hoehe_StickNeutralPoint;// Wert : 0-250
unsigned char Stick_P; // Wert : 1-6
unsigned char Stick_D; // Wert : 0-64
unsigned char Gier_P; // Wert : 1-20
unsigned char Gas_Min; // Wert : 0-32
unsigned char Gas_Max; // Wert : 33-250
unsigned char GyroAccFaktor; // Wert : 1-64
unsigned char KompassWirkung; // Wert : 0-32
unsigned char Gyro_P; // Wert : 10-250
unsigned char Gyro_I; // Wert : 0-250
unsigned char Gyro_D; // Wert : 0-250
unsigned char Gyro_Gier_P; // Wert : 10-250
unsigned char Gyro_Gier_I; // Wert : 0-250
unsigned char UnterspannungsWarnung; // Wert : 0-250
unsigned char NotGas; // Wert : 0-250 //Gaswert bei Empängsverlust
unsigned char NotGasZeit; // Wert : 0-250 // Zeitbis auf NotGas geschaltet wird, wg. Rx-Problemen
unsigned char Receiver; // 0= Summensignal, 1= Spektrum, 2 =Jeti, 3=ACT DSL, 4=ACT S3D
unsigned char I_Faktor; // Wert : 0-250
unsigned char UserParam1; // Wert : 0-250
unsigned char UserParam2; // Wert : 0-250
unsigned char UserParam3; // Wert : 0-250
unsigned char UserParam4; // Wert : 0-250
unsigned char ServoNickControl; // Wert : 0-250 // Stellung des Servos
unsigned char ServoNickComp; // Wert : 0-250 // Einfluss Gyro/Servo
unsigned char ServoNickMin; // Wert : 0-250 // Anschlag
unsigned char ServoNickMax; // Wert : 0-250 // Anschlag
//--- Seit V0.75
unsigned char ServoRollControl; // Wert : 0-250 // Stellung des Servos
unsigned char ServoRollComp; // Wert : 0-250
unsigned char ServoRollMin; // Wert : 0-250
unsigned char ServoRollMax; // Wert : 0-250
//---
unsigned char ServoNickRefresh; // Speed of the Servo
unsigned char Servo3; // Value or mapping of the Servo Output
unsigned char Servo4; // Value or mapping of the Servo Output
unsigned char Servo5; // Value or mapping of the Servo Output
unsigned char LoopGasLimit; // Wert: 0-250 max. Gas während Looping
unsigned char LoopThreshold; // Wert: 0-250 Schwelle für Stickausschlag
unsigned char LoopHysterese; // Wert: 0-250 Hysterese für Stickausschlag
unsigned char AchsKopplung1; // Wert: 0-250 Faktor, mit dem Gier die Achsen Roll und Nick koppelt (NickRollMitkopplung)
unsigned char AchsKopplung2; // Wert: 0-250 Faktor, mit dem Nick und Roll verkoppelt werden
unsigned char CouplingYawCorrection; // Wert: 0-250 Faktor, mit dem Nick und Roll verkoppelt werden
unsigned char WinkelUmschlagNick; // Wert: 0-250 180°-Punkt
unsigned char WinkelUmschlagRoll; // Wert: 0-250 180°-Punkt
unsigned char GyroAccAbgleich; // 1/k (Koppel_ACC_Wirkung)
unsigned char Driftkomp;
unsigned char DynamicStability;
unsigned char UserParam5; // Wert : 0-250
unsigned char UserParam6; // Wert : 0-250
unsigned char UserParam7; // Wert : 0-250
unsigned char UserParam8; // Wert : 0-250
//---Output ---------------------------------------------
unsigned char J16Bitmask; // for the J16 Output
unsigned char J16Timing; // for the J16 Output
unsigned char J17Bitmask; // for the J17 Output
unsigned char J17Timing; // for the J17 Output
// seit version V0.75c
unsigned char WARN_J16_Bitmask; // for the J16 Output
unsigned char WARN_J17_Bitmask; // for the J17 Output
//---NaviCtrl---------------------------------------------
unsigned char NaviGpsModeControl; // Parameters for the Naviboard
unsigned char NaviGpsGain;
unsigned char NaviGpsP;
unsigned char NaviGpsI;
unsigned char NaviGpsD;
unsigned char NaviGpsPLimit;
unsigned char NaviGpsILimit;
unsigned char NaviGpsDLimit;
unsigned char NaviGpsACC;
unsigned char NaviGpsMinSat;
unsigned char NaviStickThreshold;
unsigned char NaviWindCorrection;
unsigned char NaviSpeedCompensation;
unsigned char NaviOperatingRadius;
unsigned char NaviAngleLimitation;
unsigned char NaviPH_LoginTime;
//---Ext.Ctrl---------------------------------------------
unsigned char ExternalControl; // for serial Control
//------------------------------------------------
unsigned char BitConfig; // (war Loop-Cfg) Bitcodiert: 0x01=oben, 0x02=unten, 0x04=links, 0x08=rechts / wird getrennt behandelt
unsigned char ServoCompInvert; // // 0x01 = Nick, 0x02 = Roll 0 oder 1 // WICHTIG!!! am Ende lassen
unsigned char ExtraConfig; // bitcodiert
char Name[12];
};
struct
{
char Revision;
char Name[12];
signed char Motor[16][4];
} Mixer;
extern struct mk_param_struct EE_Parameter;
extern unsigned char Parameter_Luftdruck_D;
extern unsigned char Parameter_MaxHoehe;
extern unsigned char Parameter_Hoehe_P;
extern unsigned char Parameter_Hoehe_ACC_Wirkung;
extern unsigned char Parameter_KompassWirkung;
extern unsigned char Parameter_Gyro_P;
extern unsigned char Parameter_Gyro_I;
extern unsigned char Parameter_Gier_P;
extern unsigned char Parameter_ServoNickControl;
extern unsigned char Parameter_ServoRollControl;
extern unsigned char Parameter_AchsKopplung1;
extern unsigned char Parameter_AchsKopplung2;
//extern unsigned char Parameter_AchsGegenKopplung1;
extern unsigned char Parameter_J16Bitmask; // for the J16 Output
extern unsigned char Parameter_J16Timing; // for the J16 Output
extern unsigned char Parameter_J17Bitmask; // for the J17 Output
extern unsigned char Parameter_J17Timing; // for the J17 Output
extern signed char MixerTable[MAX_MOTORS][4];
#endif //_FC_H