Rev 1805 |
Rev 1854 |
Go to most recent revision |
Blame |
Compare with Previous |
Last modification |
View Log
| RSS feed
#ifndef _OUTPUT_H
#define _OUTPUT_H
#include <avr/io.h>
// This is for LEDs connected directly between +5V and the AVR port, without transistors.
// PORTbit = 0 --> LED on.
// To use the normal transistor set-up where 1 --> transistor conductive, reverse the
// ON and OFF statements.
// invert means: An "1" bit in digital debug data make a LOW on the output.
#define DIGITAL_DEBUG_INVERT 1
#define OUTPUT_HIGH(num) {PORTC |= (4 << (num));}
#define OUTPUT_LOW(num) {PORTC &= ~(4 << (num));}
#define OUTPUT_SET(num, state) {if (DIGITAL_DEBUG_INVERT){if(state) OUTPUT_LOW(num) else OUTPUT_HIGH(num)} else {if(state) OUTPUT_HIGH(num) else OUTPUT_LOW(num)}}
#define OUTPUT_TOGGLE(num) ( {PORTC ^= (4 << (num));}
#define DEBUG_LEDTEST 256
#define DEBUG_HEIGHT_SWITCH 1
#define DEBUG_HEIGHT_DIFF 2
#define DEBUG_HOVERTHROTTLE 4
#define DEBUG_ACC0THORDER 8
#define DEBUG_COMMANDREPEATED 16
#define DEBUG_PRESSURERANGE 32
#define DEBUG_CLIP 64
void output_init(void);
void output_update(void);
#endif //_output_H