Rev 362 | Rev 378 | Go to most recent revision | Show entire file | Ignore whitespace | Details | Blame | Last modification | View Log | RSS feed
Rev 362 | Rev 369 | ||
---|---|---|---|
Line 175... | Line 175... | ||
175 | GPIO_InitStructure.GPIO_Type = GPIO_Type_PushPull ; |
175 | GPIO_InitStructure.GPIO_Type = GPIO_Type_PushPull ; |
176 | GPIO_InitStructure.GPIO_IPInputConnected = GPIO_IPInputConnected_Disable; |
176 | GPIO_InitStructure.GPIO_IPInputConnected = GPIO_IPInputConnected_Disable; |
177 | GPIO_InitStructure.GPIO_Alternate = GPIO_InputAlt1; |
177 | GPIO_InitStructure.GPIO_Alternate = GPIO_InputAlt1; |
178 | GPIO_Init(GPIO5, &GPIO_InitStructure); |
178 | GPIO_Init(GPIO5, &GPIO_InitStructure); |
Line -... | Line 179... | ||
- | 179 | ||
179 | 180 | /* |
|
180 | // configure the EXT11 interrupt line (P5.3) as an IRQ with the lowest priority |
181 | // configure the EXT11 interrupt line (P5.3) as an IRQ with the lowest priority |
181 | SCU_APBPeriphClockConfig(__WIU, ENABLE); |
182 | SCU_APBPeriphClockConfig(__WIU, ENABLE); |
182 | WIU_Cmd(ENABLE); |
183 | WIU_Cmd(ENABLE); |
183 | WIU_ClearITPendingBit(WIU_Line11); |
184 | WIU_ClearITPendingBit(WIU_Line11); |
Line 188... | Line 189... | ||
188 | // The EXTIT1_IRQHandler() is called every time the SD-Switch is activated (falling edge) |
189 | // The EXTIT1_IRQHandler() is called every time the SD-Switch is activated (falling edge) |
189 | // by inserting an sd-card |
190 | // by inserting an sd-card |
190 | SCU_WakeUpLineConfig(11); |
191 | SCU_WakeUpLineConfig(11); |
191 | VIC_Config(EXTIT1_ITLine, VIC_IRQ, PRIORITY_SDSWITCH); |
192 | VIC_Config(EXTIT1_ITLine, VIC_IRQ, PRIORITY_SDSWITCH); |
192 | VIC_ITCmd(EXTIT1_ITLine, ENABLE); |
193 | VIC_ITCmd(EXTIT1_ITLine, ENABLE); |
- | 194 | */ |
|
193 | } |
195 | } |
Line 194... | Line 196... | ||
194 | 196 | ||
195 | void SSC_Deinit(void) |
197 | void SSC_Deinit(void) |
196 | { |
198 | { |