Rev 367 | Rev 379 | Go to most recent revision | Show entire file | Ignore whitespace | Details | Blame | Last modification | View Log | RSS feed
| Rev 367 | Rev 368 | ||
|---|---|---|---|
| Line 28... | Line 28... | ||
| 28 | 28 | ||
| 29 | Instructions: |
29 | Instructions: |
| 30 | Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl. |
30 | Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl. |
| Line 31... | Line -... | ||
| 31 | You will need NaviCtrl 0.15c soft to fully enjoy the software. |
- | |
| 32 | 31 | You will need NaviCtrl 0.15c soft to fully enjoy the software. |
|
| Line 33... | Line 32... | ||
| 33 | <<<<<<< .mine |
32 | |
| 34 | S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
33 | S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
| 35 | 34 | ||
| Line 46... | Line 45... | ||
| 46 | Setup -> Interfac Setup |
45 | Setup -> Interfac Setup |
| 47 | and select the correct Serial Port and "SI Prog API" |
46 | and select the correct Serial Port and "SI Prog API" |
| 48 | - Select Chip manufacturer "AVR micro" and Chip "ATMega162" |
47 | - Select Chip manufacturer "AVR micro" and Chip "ATMega162" |
| 49 | - If this is the first time using you board check the fuses (only BOD1LEVEL and EESAVE are checked) |
48 | - If this is the first time using you board check the fuses (only BOD1LEVEL and EESAVE are checked) |
| 50 | - Open the .hex file and Writa All (Ctrl+W) |
49 | - Open the .hex file and Writa All (Ctrl+W) |
| 51 | - Hopefully done :)======= |
50 | - Hopefully done :) |
| 52 | S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
- | |
| 53 | - | ||
| 54 | >>>>>>> .r366 |
- | |
| 55 | 51 | ||