Rev 366 | Rev 368 | Go to most recent revision | Show entire file | Ignore whitespace | Details | Blame | Last modification | View Log | RSS feed
| Rev 366 | Rev 367 | ||
|---|---|---|---|
| Line 28... | Line 28... | ||
| 28 | 28 | ||
| 29 | Instructions: |
29 | Instructions: |
| 30 | Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl. |
30 | Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl. |
| Line -... | Line 31... | ||
| - | 31 | You will need NaviCtrl 0.15c soft to fully enjoy the software. |
|
| - | 32 | ||
| - | 33 | <<<<<<< .mine |
|
| - | 34 | S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
|
| - | 35 | ||
| - | 36 | How To Flash the software (the MK-user way): |
|
| - | 37 | Requirements: |
|
| - | 38 | - Windows PC with a real SerialPort |
|
| - | 39 | - PonyProg (http://www.LancOS.com) |
|
| - | 40 | - SerCon |
|
| - | 41 | HowTo: |
|
| - | 42 | - Connect the ISP1 from SerCon to the ISP connector of the EPi-OSD board using a |
|
| - | 43 | normal 1:1 cable |
|
| - | 44 | - Set the Jumper on the SerCon |
|
| - | 45 | - SetUp PonyProg |
|
| - | 46 | Setup -> Interfac Setup |
|
| - | 47 | and select the correct Serial Port and "SI Prog API" |
|
| - | 48 | - Select Chip manufacturer "AVR micro" and Chip "ATMega162" |
|
| - | 49 | - If this is the first time using you board check the fuses (only BOD1LEVEL and EESAVE are checked) |
|
| 31 | You will need NaviCtrl 0.15c soft to fully enjoy the software. |
50 | - Open the .hex file and Writa All (Ctrl+W) |
| Line 32... | Line -... | ||
| 32 | - | ||
| 33 | S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
51 | - Hopefully done :)======= |
| - | 52 | S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
|