| 30,6 → 30,25 |
|---|
| Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl. |
| You will need NaviCtrl 0.15c soft to fully enjoy the software. |
| |
| <<<<<<< .mine |
| S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
| |
| How To Flash the software (the MK-user way): |
| Requirements: |
| - Windows PC with a real SerialPort |
| - PonyProg (http://www.LancOS.com) |
| - SerCon |
| HowTo: |
| - Connect the ISP1 from SerCon to the ISP connector of the EPi-OSD board using a |
| normal 1:1 cable |
| - Set the Jumper on the SerCon |
| - SetUp PonyProg |
| Setup -> Interfac Setup |
| and select the correct Serial Port and "SI Prog API" |
| - Select Chip manufacturer "AVR micro" and Chip "ATMega162" |
| - If this is the first time using you board check the fuses (only BOD1LEVEL and EESAVE are checked) |
| - Open the .hex file and Writa All (Ctrl+W) |
| - Hopefully done :)======= |
| S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
| |
| |
| >>>>>>> .r366 |