| 33,7 → 33,7 |
|---|
| |
| Instructions: |
| Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl. |
| You will need at least NaviCtrl 0.28h soft to fully enjoy the software. |
| You will need at least NaviCtrl 2.04a soft to fully enjoy the software. |
| |
| S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1 |
| |
| 72,12 → 72,14 |
|---|
| - avrdude |
| HowTo: |
| - assuming your ISP programmer is a usbasp compatible connected via usb |
| - fuses: |
| avrdude -c usbasp -P usb -p m162 -u -v -U lfuse:w:0xff:m -U hfuse:w:0xD7:m -U efuse:w:0xFB:m |
| - firmware: |
| avrdude -c usbasp -P usb -p m162 -u -U flash:w:C-OSD-######.hex |
| - for serial port programming using the SerCon |
| avrdude -p m162 -c siprog -P COM1 *****************look above***************** |
| - adjust supplied flash-usbasp.bat (according to your programmer and recent firmware) |
| - OR use the following commands |
| - fuses: |
| avrdude -c usbasp -p m162 -u -v -U lfuse:w:0xff:m -U hfuse:w:0xd7:m -U efuse:w:0xfb:m |
| - firmware: |
| avrdude -c usbasp -P usb -p m162 -u -U flash:w:C-OSD-######.hex |
| - for serial port programming using the SerCon |
| avrdude -c siprog -P COM1 -p m162 *****************look above***************** |
| |
| |
| #EOF |