Rev 136 | Rev 141 | Go to most recent revision | Details | Compare with Previous | Last modification | View Log | RSS feed
Rev | Author | Line No. | Line |
---|---|---|---|
136 | killagreg | 1 | #ifndef _CONFIG_H |
2 | #define _CONFIG_H |
||
3 | |||
4 | // Configure the interrupt priority at a level from 0 to 15 (0 is highest priority) |
||
5 | #define PRIORITY_SPI0 1 // timing forced by FC |
||
139 | killagreg | 6 | #define PRIORITY_USB 2 // |
7 | #define PRIORITY_UART0 3 // uart to GPS/MK3MAG |
||
8 | #define PRIORITY_UART1 5 // debug uart |
||
9 | #define PRIORITY_UART2 4 // uart to FC |
||
136 | killagreg | 10 | #define PRIORITY_I2C1 7 // i2c to MK3MAG |
11 | #define PRIORITY_TIMER1 8 // system time |
||
139 | killagreg | 12 | #define PRIORITY_TIMER2 6 // servo pwm |
136 | killagreg | 13 | #define PRIORITY_ADC 14 // adc conversion |
14 | #define PRIORITY_SDSWITCH 15 // switch at sd port |
||
15 | |||
16 | #define UART0_BAUD_RATE 57600 //Baud Rate for the serial interfaces |
||
17 | #define UART1_BAUD_RATE 57600 //Baud Rate for the serial interfaces |
||
18 | #define UART2_BAUD_RATE 57600 //Baud Rate for the serial interfaces |
||
19 | #define I2C1_CLOCK 20000 // 20 kHz |
||
20 | |||
21 | #endif // _CONFIG_H |