Subversion Repositories FlightCtrl

Rev

Rev 1926 | Go to most recent revision | Details | Compare with Previous | Last modification | View Log | RSS feed

Rev Author Line No. Line
1910 - 1
/*********************************************************************************/
2
/* Attitude sense system (processing of gyro, accelerometer and altimeter data)  */
3
/*********************************************************************************/
4
 
5
#ifndef _ATTITUDE_H
6
#define _ATTITUDE_H
7
 
8
#include <inttypes.h>
9
 
10
#include "analog.h"
11
 
12
// For debugging only.
13
#include "uart0.h"
14
 
15
/*
16
 * If you have no acc. sensor or do not want to use it, remove this define. This will cause the
17
 * acc. sensor to be ignored at attitude calibration.
18
 */
19
#define ATTITUDE_USE_ACC_SENSORS yes
20
 
21
/*
22
 * The frequency at which numerical integration takes place. 488 in original code.
23
 */
24
#define INTEGRATION_FREQUENCY 488
25
 
26
/*
27
 * Gyro readings are divided by this before being used in attitude control. This will scale them
28
 * to match the scale of the stick control etc. variables. This is just a rough non-precision
29
 * scaling - the below definitions make precise conversion factors.
30
 * Will be about 4 for InvenSense, 8 for FC1.3 and 8 for ADXRS610.
31
 * The number 1250 is derived from the original code: It has about 225000 = 1250 * 180 for 180 degrees.
32
 */
33
#define HIRES_GYRO_INTEGRATION_FACTOR 1
34
// (int)((GYRO_RATE_FACTOR_PITCHROLL * INTEGRATION_FREQUENCY * GYRO_PITCHROLL_CORRECTION) / 1250)
35
 
36
/*
37
 * Constant for deriving an attitude angle from acceleration measurement.
38
 *
39
 * The value is derived from the datasheet of the ACC sensor where 5g are scaled to VRef.
40
 * 1g is (3V * 1024) / (5 * 3V) = 205 counts. The ADC ISR sums 2 acc. samples to each
41
 * [pitch/roll]AxisAcc and thus reads about acc = 410 counts / g.
42
 * We approximate a small pitch/roll angle v by assuming that the copter does not accelerate:
43
 * In this explanation it is assumed that the ADC values are 0 based, and gravity is included.
44
 * The sine of v is the far side / the hypothenusis:
45
 * sin v = acc / sqrt(acc^2 + acc_z^2)
46
 * Using that v is a small angle, and the near side is about equal to the the hypothenusis:
47
 * sin v ~= acc / acc_z
48
 * Assuming that the helicopter is hovering at small pitch and roll angles, acc_z is about 410,
49
 * and sin v ~= v (small angles, in radians):
50
 * sin v ~= acc / 410
51
 * v / 57.3 ~= acc / 410
52
 * v ~= acc * 57.3 / 410
53
 * acc / v ~= 410 / 57.3 ~= 7, that is: There are about 7 counts per degree.
54
 *
55
 * Summary: DEG_ACC_FACTOR = (2 * 1024 * [sensitivity of acc. meter in V/g]) / (3V * 57.3)
56
 */
57
#define DEG_ACC_FACTOR 7
58
 
59
/*
60
 * Growth of the integral per degree:
61
 * The hiResXXXX value per deg / s * INTEGRATION_FREQUENCY samples / sec * correction / a number divided by
62
 * HIRES_GYRO_INTEGRATION_FACTOR (why???) before integration.
63
 * The value of this expression should be about 1250 (by setting HIRES_GYRO_INTEGRATION_FACTOR to something suitable).
64
 */
65
#define GYRO_DEG_FACTOR_PITCHROLL (GYRO_RATE_FACTOR_PITCHROLL * INTEGRATION_FREQUENCY * GYRO_PITCHROLL_CORRECTION / HIRES_GYRO_INTEGRATION_FACTOR)
66
#define GYRO_DEG_FACTOR_YAW (GYRO_RATE_FACTOR_YAW * INTEGRATION_FREQUENCY * GYRO_YAW_CORRECTION)
67
 
68
/*
69
 * This is ([gyro integral value] / degree) / (degree / acc. sensor value) = gyro integral value / acc.sensor value
70
 * = the factor an acc. sensor should be multiplied by to get the gyro integral
71
 * value for the same (small) angle.
72
 * The value is about 200.
73
 */
74
#define GYRO_ACC_FACTOR ((GYRO_DEG_FACTOR_PITCHROLL) / (DEG_ACC_FACTOR))
75
 
76
#define PITCHROLLOVER180 ((int32_t)GYRO_DEG_FACTOR_PITCHROLL * 180)
77
#define PITCHROLLOVER360 ((int32_t)GYRO_DEG_FACTOR_PITCHROLL * 360)
78
#define YAWOVER360       ((int32_t)GYRO_DEG_FACTOR_YAW * 360)
79
 
80
/*
81
 * Rotation rates
82
 */
83
extern int16_t rate_PID[2], rate_ATT[2], yawRate;
84
extern int16_t differential[3];
85
 
86
/*
87
 * Attitudes calculated by numerical integration of gyro rates
88
 */
1927 - 89
extern int32_t angle[3];
90
extern int32_t error[3];
1910 - 91
 
92
/*
93
 * Dynamic gyro offsets. These are signed values that are subtracted from the gyro measurements,
94
 * to help canceling out drift and vibration noise effects. The dynamic offsets themselves
95
 * can be updated in flight by different ways, for example:
96
 * - Just taking them from parameters, so the pilot can trim manually in a PC or mobile tool
97
 * - Summing up how much acc. meter correction was done to the gyro integrals over the last n
98
 *   integration, and then adding the sum / n to the dynamic offset
99
 * - Detect which way the pilot pulls the stick to keep the copter steady, and correct by that
100
 * - Invent your own...
101
 */
102
extern int16_t dynamicOffset[2], dynamicOffsetYaw;
103
 
104
/*
105
 * For NaviCtrl use.
106
 */
107
extern int16_t averageAcc[2], averageAccCount;
108
 
109
/*
110
 * Re-init flight attitude, setting all angles to 0 (or to whatever can be derived from acc. sensor).
111
 * To be called when the pilot commands gyro calibration (eg. by moving the left stick up-left or up-right).
112
 */
113
void attitude_setNeutral(void);
114
 
115
/*
116
 * Experiment.
117
 */
118
// void attitude_startDynamicCalibration(void);
119
// void attitude_continueDynamicCalibration(void);
120
 
121
int32_t getAngleEstimateFromAcc(uint8_t axis);
122
 
123
/*
124
 * Main routine, called from the flight loop.
125
 */
126
void calculateFlightAttitude(void);
127
#endif //_ATTITUDE_H