Details | Last modification | View Log | RSS feed
Rev | Author | Line No. | Line |
---|---|---|---|
1456 | acid | 1 | |
2 | atmega8 8mhz |
||
3 | |||
1461 | acid | 4 | wiring |
1456 | acid | 5 | |
1461 | acid | 6 | GND |
7 | VCC |
||
8 | RESET |
||
9 | SCL |
||
10 | SDA |
||
1456 | acid | 11 | |
1461 | acid | 12 | Status LED = PD7 (high = on) |
1456 | acid | 13 | |
1461 | acid | 14 | servo PWM 1 = PB0 |
15 | servo 2 = PB1 |
||
16 | servo 3 = PB2 |
||
17 | servo 4 = PB3 |
||
18 | servo 5 = PB4 |
||
19 | servo 6 = PB5 |
||
1456 | acid | 20 | |
1461 | acid | 21 | LED status |
1456 | acid | 22 | |
1463 | acid | 23 | LED on = ready, no signal |
1461 | acid | 24 | LED blinking fast = I2C data received |
1464 | acid | 25 | LED blinking slowly (1 second) = servos not configured |
1460 | acid | 26 | |
27 | |||
1461 | acid | 28 | UART programming mode (9600 baud) |
1460 | acid | 29 | |
1461 | acid | 30 | DISPLAY Display servo settings |
31 | EXPORT Export srvo settings |
||
32 | SET s=n[,l,u] Set servo settings |
||
33 | s = servo number (1-6) |
||
34 | n = neutral position (0-255) |
||
35 | l = lower limit (0-255) |
||
36 | u = upper limit (0-255) |
||
37 | CUR n Set current servo. increase neutral value with + and decrease it with - |
||
38 | LOAD Load settings from eeprom |
||
39 | SAVE Write settings to eeprom |