Rev 136 |
Rev 141 |
Go to most recent revision |
Blame |
Compare with Previous |
Last modification |
View Log
| RSS feed
#ifndef _CONFIG_H
#define _CONFIG_H
// Configure the interrupt priority at a level from 0 to 15 (0 is highest priority)
#define PRIORITY_SPI0 1 // timing forced by FC
#define PRIORITY_USB 2 //
#define PRIORITY_UART0 3 // uart to GPS/MK3MAG
#define PRIORITY_UART1 5 // debug uart
#define PRIORITY_UART2 4 // uart to FC
#define PRIORITY_I2C1 7 // i2c to MK3MAG
#define PRIORITY_TIMER1 8 // system time
#define PRIORITY_TIMER2 6 // servo pwm
#define PRIORITY_ADC 14 // adc conversion
#define PRIORITY_SDSWITCH 15 // switch at sd port
#define UART0_BAUD_RATE 57600 //Baud Rate for the serial interfaces
#define UART1_BAUD_RATE 57600 //Baud Rate for the serial interfaces
#define UART2_BAUD_RATE 57600 //Baud Rate for the serial interfaces
#define I2C1_CLOCK 20000 // 20 kHz
#endif // _CONFIG_H