Rev 368 | Rev 514 | Go to most recent revision | Blame | Compare with Previous | Last modification | View Log | RSS feed
/****************************************************************************
* Copyright (C) 2009 by Claas Anders "CaScAdE" Rathje *
* admiralcascade@gmail.com *
* Project-URL: http://www.mylifesucks.de/oss/c-osd/ *
* *
* This program is free software; you can redistribute it and/or modify *
* it under the terms of the GNU General Public License as published by *
* the Free Software Foundation; either version 2 of the License. *
* *
* This program is distributed in the hope that it will be useful, *
* but WITHOUT ANY WARRANTY; without even the implied warranty of *
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the *
* GNU General Public License for more details. *
* *
* You should have received a copy of the GNU General Public License *
* along with this program; if not, write to the *
* Free Software Foundation, Inc., *
* 59 Temple Place - Suite 330, Boston, MA 02111-1307, USA. *
****************************************************************************/
Look at
http://www.mylifesucks.de/oss/c-osd/
to see what this is all about.
Simple way:
- Flash C-OSD-characters* (wait till all chars appear on screen before flashing next)
- Flash C-OSD-*-(pal|ntsc) acording to your needs
If you already have flashed a specific character file (or more) and you just want to
update the software itself, you do not need to flash the character files again.
Instructions:
Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl.
You will need NaviCtrl 0.15c soft to fully enjoy the software.
S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1
How To Flash the software (the MK-user way):
Requirements:
- Windows PC with a real SerialPort
- PonyProg (http://www.LancOS.com)
- SerCon
HowTo:
- Connect the ISP1 from SerCon to the ISP connector of the EPi-OSD board using a
normal 1:1 cable
- Set the Jumper on the SerCon
- SetUp PonyProg
Setup -> Interfac Setup
and select the correct Serial Port and "SI Prog API"
- Select Chip manufacturer "AVR micro" and Chip "ATMega162"
- If this is the first time using you board check the fuses (only BOD1LEVEL and EESAVE are checked)
- Open the .hex file and Writa All (Ctrl+W)
- Hopefully done :)