Subversion Repositories Projects

Rev

Rev 2039 | Rev 2043 | Go to most recent revision | Show entire file | Ignore whitespace | Details | Blame | Last modification | View Log | RSS feed

Rev 2039 Rev 2041
Line 31... Line 31...
31
	If you already have flashed the character file and you just want to
31
	If you already have flashed the character file and you just want to
32
	update the software itself, you do not need to flash the character files again.
32
	update the software itself, you do not need to flash the character files again.
33
 
33
 
34
Instructions:
34
Instructions:
35
	Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl.
35
	Connect the "To FC" port from EPi-OSD to the Debug port of the NaviCtrl.
36
	You will need at least NaviCtrl 0.28h soft to fully enjoy the software.
36
	You will need at least NaviCtrl 2.04a soft to fully enjoy the software.
37
 
37
 
38
	S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1
38
	S1 enters a menu where you can cycle through using S2 and toggle/accept choice with S1
39
 
39
 
40
	You can connect a spare RC-Channel to the PPM connector and enable/disable the HUD remotely with it, hopefully.
40
	You can connect a spare RC-Channel to the PPM connector and enable/disable the HUD remotely with it, hopefully.
41
 
41
 
Line 70... Line 70...
70
        Requirements:
70
        Requirements:
71
                - ISP-Programmer which is supported by avrdude (SerCon, usbasp, AVRISP-MKII and so on...)
71
                - ISP-Programmer which is supported by avrdude (SerCon, usbasp, AVRISP-MKII and so on...)
72
                - avrdude
72
                - avrdude
73
        HowTo:
73
        HowTo:
74
                - assuming your ISP programmer is a usbasp compatible connected via usb
74
                - assuming your ISP programmer is a usbasp compatible connected via usb
-
 
75
				- adjust supplied flash-usbasp.bat (according to your programmer and recent firmware)
-
 
76
				- OR use the following commands
75
                - fuses:
77
					- fuses:
76
                    avrdude -c usbasp -P usb -p m162  -u -v -U lfuse:w:0xff:m -U hfuse:w:0xD7:m -U efuse:w:0xFB:m
78
						avrdude -c usbasp -p m162 -u -v -U lfuse:w:0xff:m -U hfuse:w:0xd7:m -U efuse:w:0xfb:m
77
                - firmware:
79
					- firmware:
78
                    avrdude -c usbasp -P usb -p m162 -u -U flash:w:C-OSD-######.hex
80
						avrdude -c usbasp -P usb -p m162 -u -U flash:w:C-OSD-######.hex
79
                - for serial port programming using the SerCon
81
					- for serial port programming using the SerCon
80
                    avrdude -p m162 -c siprog -P COM1 *****************look above*****************
82
						avrdude -c siprog -P COM1 -p m162 *****************look above*****************
81
 
83
 
82
 
84
 
83
#EOF
85
#EOF