| 4,139 → 4,106 |
|---|
| |
| #ifndef _FC_H |
| #define _FC_H |
| //#define GIER_GRAD_FAKTOR 1450L // Abhängigkeit wzischen GyroIntegral und Winkel |
| #define GIER_GRAD_FAKTOR 1550L // Abhängigkeit wzischen GyroIntegral und Winkel |
| |
| #include <inttypes.h> |
| |
| #define YAW_GYRO_DEG_FACTOR 1550L // Factor between Yaw Gyro Integral and HeadingAngle in deg |
| #define STICK_GAIN 4 |
| extern volatile unsigned int I2CTimeout; |
| extern unsigned char Sekunde,Minute; |
| extern long IntegralNick,IntegralNick2; |
| extern long IntegralRoll,IntegralRoll2; |
| extern long Mess_IntegralNick,Mess_IntegralNick2; |
| extern long Mess_IntegralRoll,Mess_IntegralRoll2; |
| extern long IntegralAccNick,IntegralAccRoll; |
| extern volatile long Mess_Integral_Hoch; |
| extern long Integral_Gier,Mess_Integral_Gier,Mess_Integral_Gier2; |
| extern volatile int KompassValue; |
| extern volatile int KompassStartwert; |
| extern volatile int KompassRichtung; |
| extern long ErsatzKompass; |
| extern int ErsatzKompassInGrad; // Kompasswert in Grad |
| extern int HoehenWert; |
| extern int SollHoehe; |
| extern volatile int MesswertNick,MesswertRoll,MesswertGier; |
| extern volatile int AdNeutralNick,AdNeutralRoll,AdNeutralGier, Mittelwert_AccNick, Mittelwert_AccRoll; |
| extern volatile int NeutralAccX, NeutralAccY,Mittelwert_AccHoch; |
| |
| typedef struct |
| { |
| uint8_t Height_D; |
| uint8_t MaxHeight; |
| uint8_t Height_P; |
| uint8_t Height_ACC_Effect; |
| uint8_t CompassYawEffect; |
| uint8_t Gyro_P; |
| uint8_t Gyro_I; |
| uint8_t Gier_P; |
| uint8_t I_Factor; |
| uint8_t UserParam1; |
| uint8_t UserParam2; |
| uint8_t UserParam3; |
| uint8_t UserParam4; |
| uint8_t UserParam5; |
| uint8_t UserParam6; |
| uint8_t UserParam7; |
| uint8_t UserParam8; |
| uint8_t ServoPitchControl; |
| uint8_t LoopThrustLimit; |
| uint8_t Yaw_PosFeedback; |
| uint8_t Yaw_NegFeedback; |
| uint8_t DynamicStability; |
| } fc_param_t; |
| |
| extern fc_param_t FCParam; |
| |
| extern volatile uint16_t I2CTimeout; |
| |
| // attitude |
| extern volatile int32_t IntegralPitch, IntegralRoll, IntegralYaw; |
| extern volatile int16_t Reading_GyroPitch, Reading_GyroRoll, Reading_GyroYaw; |
| |
| // offsets |
| extern volatile int16_t AdNeutralPitch, AdNeutralRoll, AdNeutralYaw; |
| extern volatile int16_t NeutralAccX, NeutralAccY; |
| extern volatile float NeutralAccZ; |
| extern long Umschlag180Nick, Umschlag180Roll; |
| extern signed int ExternStickNick,ExternStickRoll,ExternStickGier; |
| extern unsigned char Parameter_UserParam1,Parameter_UserParam2,Parameter_UserParam3,Parameter_UserParam4,Parameter_UserParam5,Parameter_UserParam6,Parameter_UserParam7,Parameter_UserParam8; |
| extern int NaviAccNick,NaviAccRoll,NaviCntAcc; |
| extern unsigned int modell_fliegt; |
| void MotorRegler(void); |
| |
| |
| extern volatile int32_t Reading_Integral_Top; // calculated in analog.c |
| |
| // compass navigation |
| extern volatile int16_t CompassHeading; |
| extern volatile int16_t CompassCourse; |
| extern volatile int16_t CompassOffCourse; |
| extern volatile uint8_t CompassCalState; |
| extern int32_t YawGyroHeading; |
| extern int16_t YawGyroHeadingInDeg; |
| |
| // hight control |
| extern int ReadingHeight; |
| extern int SetPointHeight; |
| |
| // mean accelerations |
| extern volatile int16_t Mean_AccPitch, Mean_AccRoll, Mean_AccTop; |
| |
| // acceleration send to navi board |
| extern int16_t NaviAccPitch, NaviAccRoll, NaviCntAcc; |
| |
| |
| // looping params |
| extern long TurnOver180Pitch, TurnOver180Roll; |
| |
| // external control |
| extern int16_t ExternStickPitch, ExternStickRoll, ExternStickYaw; |
| |
| |
| void MotorControl(void); |
| void SendMotorData(void); |
| void CalibrierMittelwert(void); |
| void Mittelwert(void); |
| void CalibMean(void); |
| void Mean(void); |
| void SetNeutral(void); |
| void Piep(unsigned char Anzahl); |
| extern void DefaultKonstanten(void); |
| void DefaultKonstanten1(void); |
| void DefaultKonstanten2(void); |
| void Beep(uint8_t numbeeps); |
| |
| extern unsigned char h,m,s; |
| extern volatile unsigned char Timeout ; |
| extern unsigned char CosinusNickWinkel, CosinusRollWinkel; |
| extern volatile int DiffNick,DiffRoll; |
| extern int Poti1, Poti2, Poti3, Poti4; |
| extern volatile unsigned char Motor_Vorne,Motor_Hinten,Motor_Rechts,Motor_Links, Count; |
| extern volatile unsigned char SenderOkay; |
| extern int StickNick,StickRoll,StickGier; |
| extern char MotorenEin; |
| extern void DefaultKonstanten1(void); |
| extern void DefaultKonstanten2(void); |
| |
| #define STRUCT_PARAM_LAENGE 71 |
| struct mk_param_struct |
| { |
| unsigned char Kanalbelegung[8]; // GAS[0], GIER[1],NICK[2], ROLL[3], POTI1, POTI2, POTI3 |
| unsigned char GlobalConfig; // 0x01=Höhenregler aktiv,0x02=Kompass aktiv, 0x04=GPS aktiv, 0x08=Heading Hold aktiv |
| unsigned char Hoehe_MinGas; // Wert : 0-100 |
| unsigned char Luftdruck_D; // Wert : 0-250 |
| unsigned char MaxHoehe; // Wert : 0-32 |
| unsigned char Hoehe_P; // Wert : 0-32 |
| unsigned char Hoehe_Verstaerkung; // Wert : 0-50 |
| unsigned char Hoehe_ACC_Wirkung; // Wert : 0-250 |
| unsigned char Stick_P; // Wert : 1-6 |
| unsigned char Stick_D; // Wert : 0-64 |
| unsigned char Gier_P; // Wert : 1-20 |
| unsigned char Gas_Min; // Wert : 0-32 |
| unsigned char Gas_Max; // Wert : 33-250 |
| unsigned char GyroAccFaktor; // Wert : 1-64 |
| unsigned char KompassWirkung; // Wert : 0-32 |
| unsigned char Gyro_P; // Wert : 10-250 |
| unsigned char Gyro_I; // Wert : 0-250 |
| unsigned char UnterspannungsWarnung; // Wert : 0-250 |
| unsigned char NotGas; // Wert : 0-250 //Gaswert bei Empängsverlust |
| unsigned char NotGasZeit; // Wert : 0-250 // Zeitbis auf NotGas geschaltet wird, wg. Rx-Problemen |
| unsigned char UfoAusrichtung; // X oder + Formation |
| unsigned char I_Faktor; // Wert : 0-250 |
| unsigned char UserParam1; // Wert : 0-250 |
| unsigned char UserParam2; // Wert : 0-250 |
| unsigned char UserParam3; // Wert : 0-250 |
| unsigned char UserParam4; // Wert : 0-250 |
| unsigned char ServoNickControl; // Wert : 0-250 // Stellung des Servos |
| unsigned char ServoNickComp; // Wert : 0-250 // Einfluss Gyro/Servo |
| unsigned char ServoNickMin; // Wert : 0-250 // Anschlag |
| unsigned char ServoNickMax; // Wert : 0-250 // Anschlag |
| unsigned char ServoNickRefresh; // |
| unsigned char LoopGasLimit; // Wert: 0-250 max. Gas während Looping |
| unsigned char LoopThreshold; // Wert: 0-250 Schwelle für Stickausschlag |
| unsigned char LoopHysterese; // Wert: 0-250 Hysterese für Stickausschlag |
| unsigned char AchsKopplung1; // Wert: 0-250 Faktor, mit dem Gier die Achsen Roll und Nick koppelt (NickRollMitkopplung) |
| unsigned char AchsGegenKopplung1; // Wert: 0-250 Faktor, mit dem Gier die Achsen Roll und Nick Gegenkoppelt (NickRollGegenkopplung) |
| unsigned char WinkelUmschlagNick; // Wert: 0-250 180°-Punkt |
| unsigned char WinkelUmschlagRoll; // Wert: 0-250 180°-Punkt |
| unsigned char GyroAccAbgleich; // 1/k (Koppel_ACC_Wirkung) |
| unsigned char Driftkomp; |
| unsigned char DynamicStability; |
| unsigned char UserParam5; // Wert : 0-250 |
| unsigned char UserParam6; // Wert : 0-250 |
| unsigned char UserParam7; // Wert : 0-250 |
| unsigned char UserParam8; // Wert : 0-250 |
| extern int16_t Poti1, Poti2, Poti3, Poti4, Poti5, Poti6, Poti7, Poti8; |
| |
| //------------------------------------------------ |
| unsigned char LoopConfig; // Bitcodiert: 0x01=oben, 0x02=unten, 0x04=links, 0x08=rechts / wird getrennt behandelt |
| unsigned char ServoNickCompInvert; // Wert : 0-250 0 oder 1 // WICHTIG!!! am Ende lassen |
| unsigned char Reserved[4]; |
| char Name[12]; |
| }; |
| // setpoints for motors |
| extern volatile uint8_t Motor_Front, Motor_Rear, Motor_Right, Motor_Left; //used by twimaster isr |
| |
| // current stick values |
| extern int16_t StickPitch; |
| extern int16_t StickRoll; |
| extern int16_t StickYaw; |
| extern int16_t GPS_Pitch; |
| extern int16_t GPS_Roll; |
| |
| /* |
| unsigned char ServoNickMax; // Wert : 0-250 |
| unsigned char ServoNickRefresh; // |
| unsigned char LoopGasLimit; // Wert: 0-250 max. Gas während Looping |
| unsigned char LoopThreshold; // Wert: 0-250 Schwelle für Stickausschlag |
| //------------------------------------------------ |
| unsigned char LoopConfig; // Bitcodiert: 0x01=oben, 0x02=unten, 0x04=links, 0x08=rechts / wird getrennt behandelt |
| unsigned char ServoNickCompInvert; // Wert : 0-250 0 oder 1 // WICHTIG!!! am Ende lassen |
| unsigned char Reserved[4]; |
| char Name[12]; |
| */ |
| |
| extern struct mk_param_struct EE_Parameter; |
| // current stick elongations |
| extern int16_t MaxStickPitch, MaxStickRoll, MaxStickYaw; |
| extern uint8_t MotorsOn; |
| extern uint8_t EmergencyLanding; |
| extern uint16_t Model_Is_Flying; |
| |
| extern unsigned char Parameter_Luftdruck_D; |
| extern unsigned char Parameter_MaxHoehe; |
| extern unsigned char Parameter_Hoehe_P; |
| extern unsigned char Parameter_Hoehe_ACC_Wirkung; |
| extern unsigned char Parameter_KompassWirkung; |
| extern unsigned char Parameter_Gyro_P; |
| extern unsigned char Parameter_Gyro_I; |
| extern unsigned char Parameter_Gier_P; |
| extern unsigned char Parameter_ServoNickControl; |
| extern unsigned char Parameter_AchsKopplung1; |
| extern unsigned char Parameter_AchsGegenKopplung1; |
| |
| |
| #endif //_FC_H |
| |