Rev 1651 | Rev 1662 | Go to most recent revision | Details | Compare with Previous | Last modification | View Log | RSS feed
| Rev | Author | Line No. | Line |
|---|---|---|---|
| 1 | ingob | 1 | /*############################################################################ |
| 2 | ############################################################################*/ |
||
| 3 | |||
| 4 | #ifndef _I2C_MASTER_H |
||
| 5 | #define _I2C_MASTER_H |
||
| 6 | |||
| 7 | //############################################################################ |
||
| 8 | |||
| 9 | // I2C Konstanten |
||
| 10 | #define SCL_CLOCK 200000L |
||
| 11 | #define I2C_TIMEOUT 30000 |
||
| 12 | #define I2C_START 0x08 |
||
| 13 | #define I2C_REPEATED_START 0x10 |
||
| 14 | #define I2C_TX_SLA_ACK 0x18 |
||
| 15 | #define I2C_TX_DATA_ACK 0x28 |
||
| 16 | #define I2C_RX_SLA_ACK 0x40 |
||
| 17 | #define I2C_RX_DATA_ACK 0x50 |
||
| 18 | |||
| 19 | //############################################################################ |
||
| 20 | |||
| 918 | hbuss | 21 | extern volatile unsigned char twi_state; |
| 1650 | killagreg | 22 | extern volatile unsigned char motor,MissingMotor; |
| 23 | extern volatile unsigned char motorread; |
||
| 1 | ingob | 24 | |
| 1479 | killagreg | 25 | #define MAX_MOTORS 12 |
| 1638 | holgerb | 26 | #define MOTOR_STATE_PRESENT_MASK 0x80 |
| 27 | #define MOTOR_STATE_ERROR_MASK 0x7F |
||
| 1479 | killagreg | 28 | |
| 1638 | holgerb | 29 | #define MOTOR_STATE_NEW_PROTOCOL_MASK 0x01 |
| 30 | |||
| 1648 | killagreg | 31 | #define BLFLAG_READ_VERSION 0x01 |
| 32 | #define BLFLAG_SEND_CONFIG 0x02 |
||
| 33 | #define BLFLAG_TX_COMPLETE 0x04 |
||
| 34 | |||
| 1650 | killagreg | 35 | extern volatile unsigned char BLFlags; |
| 1648 | killagreg | 36 | |
| 1479 | killagreg | 37 | typedef struct |
| 38 | { |
||
| 1486 | killagreg | 39 | unsigned char SetPoint; // written by attitude controller |
| 40 | unsigned char State; // 7 bit for I2C error counter, highest bit indicates if motor is present |
||
| 41 | unsigned char Current; // in 0.1 A steps, read back from BL |
||
| 42 | unsigned char MaxPWM; // read back from BL is less than 255 if BL is in current limit |
||
| 1648 | killagreg | 43 | unsigned char Temperature; // old BL-Ctrl will return a 255 here |
| 1638 | holgerb | 44 | unsigned char SetPointLowerBits; // for higher Resolution |
| 45 | unsigned char Version; |
||
| 1479 | killagreg | 46 | } __attribute__((packed)) MotorData_t; |
| 47 | |||
| 48 | extern MotorData_t Motor[MAX_MOTORS]; |
||
| 49 | |||
| 304 | ingob | 50 | void i2c_reset(void); |
| 395 | hbuss | 51 | extern void i2c_init (void); // I2C initialisieren |
| 1209 | hbuss | 52 | extern void i2c_write_byte (char byte); // 1 Byte schreiben |
| 395 | hbuss | 53 | extern void i2c_reset(void); |
| 1648 | killagreg | 54 | extern void I2C_SendBLConfig(void); |
| 1 | ingob | 55 | |
| 1651 | killagreg | 56 | #define I2C_Start() {BLFlags &= ~BLFLAG_TX_COMPLETE; TWCR = (1<<TWSTA) | (1<<TWEN) | (1<<TWINT) | (1<<TWIE);} |
| 1639 | holgerb | 57 | #define I2C_Stop() {TWCR = (1<<TWEN) | (1<<TWSTO) | (1<<TWINT);} |
| 58 | #define I2C_ReceiveByte() {TWCR = (1<<TWINT) | (1<<TWEN) | (1<<TWIE) | (1<<TWEA);} |
||
| 59 | #define I2C_ReceiveLastByte() {TWCR = (1<<TWINT) | (1<<TWEN) | (1<<TWIE);} |
||
| 60 | #define i2c_write_byte(byte) {TWSR = 0x00; TWDR = byte; TWCR = (1<<TWINT) | (1<<TWEN) | (1<<TWIE);} |
||
| 61 | |||
| 1 | ingob | 62 | #endif |